SUPER MICRO Computer SUPERSERVER 6015T-INF - Manual (Page 28)

2-10
S UPER S ERVER 6015T-T/6015T-INF User's Manual
2-6 Checking the Drive Bay Setup
Next, you should check to make sure the peripheral drives and the SATA drives
and SATA backplane have been properly installed and all connections have been
made.
1. Check the SATA drives
Depending upon your system's confi guration, your system may have one or
more drives already installed. If you need to install SATA drives, please refer to
Chapter 6.
2. Check the airfl ow
Airfl ow is provided by six sets of 4-cm fans (each set of fans consists of two fans
that are mounted back to back). The system component layout was carefully
designed to direct suffi cient cooling airfl ow to the components that generate the
most heat. Note that all power and data cables have been routed in such a way
that they do not block the airfl ow generated by the fans.
3. Supplying power to the system
The last thing you must do is to provide input power to the system. Plug the
power cord from the power supply module into a high-quality power strip that
offers protection from electrical noise and power surges. It is recommended that
you use an uninterruptible power supply (UPS) source.