SUPER MICRO Computer SUPERSERVER 6015T-INF - Manual (Page 40)

5-4
S UPER S ERVER 6015T-T/6015T-INF User's Manual
5-4 I/O Ports
The I/O ports are color coded in conformance with the PC 99 specifi cation. See
Figure 5-2 below for the colors and locations of the various I/O ports.
Figure 5-1. Control Panel Header Pins
Note: Infi niBand ports are included on the X7DBT (6015T-INF) only. To prevent
damage to the port or serverboard, an Infi niBand bracket (included) must be used
to secure the connector to the I/O shield.
LAN1 LAN2
COM2 Port (Turquoise) VGA Port (Blue) USB 0/1 Ports
Figure 5-2. I/O Ports
NMI
x (Key)
Vcc 5V Stby
Vcc 3V
Vcc 3V Stby
Vcc 3V Stby
Vcc 3V
Reserved
Reset (Button)
Power (Button)
Ground
x (Key)
Power On LED
IDE/SATA LED
NIC1 LED
NIC2 LED
OH/Fan Fail LED
Reserved
Ground
Ground
2 1
20 19
Connecting the Control Panel
JF1 contains header pins for various front control panel connectors. See Figure
5-1 for the pin locations of the various front control panel buttons and LED indica-
tors. All JF1 wires have been bundled into a single ribbon cable to simplify this
connection. Make sure the red wire plugs into pin 1 as marked on the board. The
other end connects to the Control Panel PCB board, located just behind the system
status LEDs on the chassis.
Infi niBand Port