SUPER MICRO Computer SUPERSERVER 6015T-INF - Manual (Page 51)

Chapter 5: Advanced Serverboard Setup
5-15
Wake-On-LAN
The Wake-On-LAN header is des-
ignated JWOL on the serverboard.
See the table on the right for pin
defi nitions. You must enable the LAN
Wake-Up setting in BIOS to use this
function. (You must also have a LAN
card with a Wake-On-LAN connector
and cable to use this feature.)
Universal Serial Bus (USB)
There are two Universal Serial Bus
ports located on the I/O panel and
two additional USB headers located
on the serverboard. The headers,
labeled USB2 and USB3, can be
used to provide front side USB access
(cables not included). See the tables
on the right for pin defi nitions.
Wake-On-LAN
Pin Defi nitions
(JWOL)
Pin# Defi nition
1 +5V Standby
2 Ground
3 Wake-up
LAN1/2 (Ethernet Ports)
Two gigabit Ethernet ports (designated
LAN1 and LAN2) are located beside the
VGA port on the I/O backplane. These
ports accept RJ45 type cables.
USB Headers
Pin Defi nitions (USB1, USB2)
USB3/5
Pin # Defi nition USB2/4
Pin # Defi nition
1 +5V 1 +5V
2 PO- 2 PO-
3 PO+ 3 PO+
4 Ground 4 Ground
5 Key 5 NC
USB Ports Pin
Defi nitions (USB0/1)
Pin# Defi nition
1 +5V
2 PO-
3 PO+
4 Ground
5 N/A
Note: NC indicates no connection.