Stanton SCS.3M - Manual (Page 11)

Channel Fader
7
3.1.3 Channel Fader
3.1.4 Crossfader
The Channel Faders (also called line faders, upfaders, etc.)
control the volume of their associated channel before the
signal gets to the Crossfader. The touch sensitive strips on
the SCS.3m act just like the Channel Faders on a traditional
mixer, allowing you to adjust the volume of the channel.
Like the Crossfader, the Channel Fader on the SCS.3m has
a row of LEDs next to it that will indicate its position.
(Figure 3.3)
Figure 3.3
MASTER MASTER
O
1O
O
1O
At the bottom of the SCS.3m or a traditional mixer, you
will usually find a Crossfader.
The Crossfader is used to mix between sources of your
mixer. Typically, moving the crossfader to the left
transitions the audio to channel 1, and full right to channel
2. Anywhere in the middle is a mix of both channels.
As you can see, on the SCS.3m there is not a traditional
fader there to let you know the position of your crossfader.
Instead, the SCS.3m has a row of LEDs above the
crossfader that will indicate its position. (Figure 3.4)
Figure 3.4
O
1O
O
1O