Stanton SCS.3M - Manual (Page 17)

Master/Monitor Mode Button
13
3.2.7 Master/Monitor Mode Button
FX E QQ E QQ FX
MASTER
Figure 3.14
When the Master Button is engaged, the Channel Faders and
Crossfader temporarily become controls for monitor volume,
master volume, and monitor mix. The VU meters also display the
master levels for checking a clean output signal from your computer.
To enter “Master” mode, press and hold the Master button.
The SCS.3m will remain in Master mode as long as you hold your
finger on the Master button. (Figure 3.14)
3.2.8 Crossfader
FX E QQ E QQ FX
MASTER
Figure 3.15
The extended length Crossfader gives extra fine control of blending
between channels and more surface to perform multi-touch effects
with two fingers for quickly cutting in and out of channels.
(Figure 3.15)
Let’s say you wanted to emulate the sound of a crab scratch or flares
using the SCS.3m crossfader. While there is not a back stop to
bounce against, we can take advantage of multi-touch here and get
something very similar. Try holding your index finger at the furthest
end of the crossfader, and then drumming your other fingers
(middle to pinky) on the surface next to it. (Figure 3.16)
MASTER MASTER
HOLD TAP TAP TAP
Figure 3.16