Stanton SCS.3M - Manual (Page 14)

FX
MASTER
HOLD
TAP
HOLD
TAP
Slider Section
3.2.2 Slider Section
10
FX E QQ E Q FX
MASTER
Figure 3.8
The slider section features 4 virtual sliders, which can be toggled to
control EQ or FX (or any other MIDI assignable control). (Figure 3.8)
The value of each slider is shown on the LEDs next to it. If you switch
the Slider Section to a different mode (for instance, from EQ to FX
mode), the SCS.3m will remember your settings and restore them
when you switch back.
Figure 3.9
The sliders on the SCS.3m are touch sensitive “virtual faders.” Moving your finger across one is like
moving a fader, or turning a knob. Sounds pretty simple, and it is. However, there is another aspect
to the sliders that is not obvious, and that is their “multi-touch” capability.
Using multi-touch on different sliders can produce some very interesting results. The faders can also
be used as relative controls, allowing for very fine control of parameters with a total range greater
than the length of the slider.
Note: Throughout the manual we will use the HOLD
icon understand the multi-touch feature. and the TAP icon to help you
To do a multi-touch, press and hold one point on a slider, and then tap a different location.
(Figure 3.9).