Siemens SICLOCK TC 400 - Manual (Page 67)

Configuration Tool
7-65 © Siemens AG 2007 All Rights Reserved
SICLOCK
® TC 400
Parameters are displayed without value
The authorization level has been raised after a download so that higher autho-
rized parameters are now shown. However, no value was supplied for these
parameters in the lower authorized request.
You can refresh these values with the
button or read them individually.
See
Parameters (Section 7.3),
Authorization (Section 7.2.2) and
Reading parameters / writing parameters / resetting parameters to factory
settings (Section 7.3.4).
Table 7-5 Problem solutions for the configuration tool
Question/Problem Cause/Remedy