Siemens SICLOCK TC 400 - Manual (Page 76)

Parameterization and Operation on the Device
8-74 © Siemens AG 2007 All Rights Reserved
SICLOCK ® TC 400
To change the address:
1. Select the decimal place to be changed with the arrow keys
← →
.
−> The currently selected decimal place flashes.
2. Select the new number with the arrow keys
← →
.
−> The new number flashes.
3. Repeat steps 1) and 2) for all the numbers to be changed.
4. Accept the new address with OK.
−> The new address is accepted and the parameter list is displayed again for
selection.
Acknowledge events
If you have selected "Acknowledge events" in the parameter list, the following
editing dialog box appears:
The "All events" text flashes.
To acknowledge all events:
1. Confirm the acknowledgement of all events with OK.
−> The events are acknowledged and the parameter list is displayed again for
selection.
Version
If you have selected "Version" in the parameter list, the following dialog box
appears:
The display alternates between the firmware and the processor version.
You cannot make any settings in this dialog box. Press ESC or OK to return to the
display of the parameter list.
Acknowledge events:
All events
Note
All messages are acknowledged unconditionally with this function.
Version:
Firmware: 1.0.0014 ´ Version:
Processor: 1.0.0005