Smart Technologies LightRaise 40wi - Manual (Page 19)

Adjusting projector settings
The remote control’s Menu button enables you to access the on-screen display to adjust the projector
settings.
I M P O R T A N T
Keep your remote control in a safe place because there is no other way to access menu options.
N O T E
Some projector settings aren’t available for all video sources.
Setting Use Notes
Image Adjustment menu
Display Mode Indicates the projector’s display output
(SMART Presentation,
Bright Room, Dark Room, sRGB
and User). The default is SMART Presentation.
Brightness Adjusts projector brightness from 0 to
100. The default is 50.
Contrast Adjusts the difference between the
lightest and darkest parts
of the image from 0 to 100. The default is 50.
Frequency Adjusts the display data frequency of
the projected image from -5 to 5 to
match the frequency of your
computer’s graphics card. The default is 0.
This setting applies to VGA inputs
only.
Tracking Synchronizes your projector’s display
timing with your computer’s graphics
card from 0 to 63. This setting applies to VGA inputs
only.
H-position Moves the horizontal position of the
source video left or right from 0 to 100
(relative to the projected image). Don’t adjust this setting unless you’re
advised to by SMART Support.
Adjust this setting only after you make
all physical image adjustments.
This setting applies to VGA inputs
only and is useful in situations where
the source video is cut off.
V-position Moves the vertical position of the
source video up or down from -5 to 5
(relative to the projected image). Don’t adjust this setting unless you’re
advised to by SMART Support.
Adjust this setting only after you make
all physical image adjustments.
This setting applies to VGA inputs
only and is useful in situations where
the source video is cut off.
C H A P T E R 3
Using your interactive projector
13