Smart Technologies LightRaise 40wi - Manual (Page 41)

You need a Phillips No. 2 screwdriver and a flat screwdriver to complete these procedures.
g To remove the old lamp module
1. Wait at least 30 minutes for the projector to cool down.
2. Disconnect the power cable from the projector.
3. Remove the lamp cover from the projector, and then put it in a safe place.
T I P
If the cover is difficult to remove, insert a flat screwdriver or small coin into the slot on the
bottom of the lamp cover to gently pry the cover open.
4. Use the Phillips screwdriver to loosen the two captive screws from the bottom of the lamp
module.
N O T E
Don’t try to remove these screws. Captive screws can’t be removed, but they must be
loosened.
5. Use the handle on the bottom of the lamp module to slide it out and remove it from the projector.
g To put the new lamp module into the projector
1. Remove the new lamp module from its packaging.
2. Carefully place the lamp module into the projector using the handle on the top of the module.
Hold the lamp module vertically and guide it into its slot. Gently press the power end of the
lamp module against the projector to ensure the power plug makes contact with the projector’s
power receptacle.
N O T E
You should be able to place the lamp module into the projector easily without applying much
force.
3. Use the Phillips screwdriver to secure the captive screws.
C A U T I O N
Do not over-tighten the screws.
4. Carefully replace the lamp cover.
5. Connect the power cable to the wall outlet.
6. Put the old lamp module in a secure container, and handle it gently until you recycle it.
C H A P T E R 5
Maintaining your interactive projector
35