Smart Technologies LightRaise 40wi - Manual (Page 38)

g To replace the remote control battery
1. Hold down the side release on the left side of the battery holder and pull the battery holder
completely out of the remote control.
2. Remove the old battery from the battery holder and replace it with a CR2025 coin-cell battery.
I M P O R T A N T
Align the positive (+) and negative (–) signs on the battery terminals with the correct signs on
the battery holder.
3. Insert the battery holder into the remote control.
Cleaning the projector
W A R N I N G
Cleaning a wall-mounted projector can result in a fall or injury. Use caution when climbing a ladder,
and consider removing the projector from its wall-mounting bracket to clean it.
C A U T I O N
l
Never touch the mirror with your hands or a brush, and do not scrub the surface of the mirror
with a cleaning cloth. Instead, use a cleaning cloth to clean the mirror with a light touch, and
do not put any cleaning solvents on the cloth or the mirror. Do not apply pressure to the
projector lens or mirror.
l
Do not spray cleaners, solvents or compressed air directly on the projector. Do not use spray
cleaners or solvents near any part of the projector because they can damage or stain the unit.
Spraying the system could spread a chemical mist on some of the projector’s components
and lamp, resulting in damage and poor image quality.
l
Do not allow liquids or commercial solvents of any kind to flow into the projector base or
head.
C H A P T E R 5
Maintaining your interactive projector
32