Smart Technologies LightRaise 40wi - Manual (Page 3)

Important information
Read the following warnings carefully. Failure to read the warnings below or to follow the installation
instructions included with your SMART product could result in personal injury or product damage and
may void your warranty.
W A R N I N G
l
Failure to follow the installation instructions shipped with your SMART product could result in
personal injury and damage to the product.
l
Ensure that any cables extending across the floor to your SMART product are properly
bundled and marked to avoid a trip hazard.
l
Make sure an electrical socket is near your SMART product and remains easily accessible
during use.
l
To reduce the risk of fire or electric shock, do not expose the SMART product to rain or
moisture.
l
You must connect the USB cable that came with your SMART product to a computer that
has a USB compliant interface and that bears the USB logo. In addition, the USB source
computer must be compliant with CSA/UL/EN 60950 and bear the CE mark and CSA and/or
UL Mark(s) for CAS/UL 60950. This is for operating safety and to avoid damage to your
SMART product.
l
To attach the wall tether, use the appropriate hardware for your wall type. Failure to do so
could result in injury if the unit detaches from the wall.
l
Do not touch or replace the projector lamp (which will be very hot) for at least 30 minutes after
you turn it off. Failure to do so can cause severe burns.
i