Smart Technologies LightRaise 40wi - Manual (Page 24)

Setting Use Notes
System
Functionality
Set to Presenter or Whiteboard
mode.
The default is Presenter mode. In
Presenter mode, the pointer follows
the pen as you point it at the projected
image and move it.
In Whiteboard mode, the pointer only
moves when you press the pen tip
against the projection surface, or you
press the left-click button on the pen.
Battery Capacity Displays the interactive pen battery
level.
In order for the battery level, RF
strength and Pen version, to display;
the interactive pen’s status light must
be blinking green. It blinks green under
the following conditions:
l
The pen is turned on and pointed
at the projected image (not the
SMART logo screen).
l
The pen isn’t paired with a
different interactive projector.
RF Strength Displays the strength of the RF
connection between the interactive
pen and the projector.
Pen Version Displays the firmware version of the
interactive pen.
Network menu
Network and VGA
Out Activates the projector’s VGA Out and
RJ45 connector and network features. The default is off.
Status Displays the current network status
(Connected, Disconnected or Off).
IP Address Displays the projector’s current IP
address in values between 0.0.0.0 and
255.255.255.255. To change the projector’s IP address,
use the RS-232 connector (see
Network controls on page 70) or use a
DHCP server to assign a dynamic IP
address, and then set a static IP
address using the network remote
management feature (see Remotely
managing your interactive projector on
page 53).
Subnet Mask Displays the projector’s subnet mask
number in values between 0.0.0.0 and
255.255.255.255.
C H A P T E R 3
Using your interactive projector
18