Sherbourn Technologies PT-7010A - Manual (Page 20)

20
Connection Diagram 6:
Connecting a Cassette Tape or DAT
Deck
This configuration shows a Cassette Tape Deck connection where
the audio output is taken from the left and right audio outputs
(may also be labeled PLAY). If you plan to use the Cassette Tape
Deck for recording, you also must connect the PT-7010A’s TAPE
audio outputs into the Cassette Tape Deck inputs (may also be
labeled RECORD).
Depending on the type of tape deck you connect, the inputs and
outputs on the PT-7010A can be connected to TAPE or DAT. If
you have both types connected, the PT-7010A will switch
automatically on to whichever source is playing. You can’t have
both playing at the same time. In the diagram shown, recording
from any selected source is possible except recording between
Cassette Tape and DAT. This is called “dubbing” and is beyond
the design intent of the Sherbourn PT-7010A Pre/Pro/Tuner.
The Tape Deck outputs
are sometimes labeled
PLAY
The Tape Deck outputs
are sometimes labeled
RECORD