Sherbourn Technologies PT-7010A - Manual (Page 31)

31
Programming and Configuring
Your Components
You must enter the SETUP mode to program the remote
control for the other components in your system, and to
customize it for your convenience. There is only one way
to enter the SETUP mode: Hold down both the MAIN
and ENT buttons for a few seconds until SETUP appears
in the display.
The SETUP display shows 10 options.
P-PRO
LEARN
FAV
MACRO
PUNCH
RECAL
ERASE
EDIT
LIGHT
CLONE
Each of these setup options is described in the subsequent
pages of this section. Please note that there are multiple
steps involved in each program sequence, so it is best to
read through the section thoroughly BEFORE beginning
to setup the PT-7010A remote.
P-PRO
The remote is pre-programmed to operate many types of
equipment. The P-PRO mode allows you to enter a 3-digit
code to recall the commands for each of your system
components.
1) Find the brand of your TV, DVD, VCR, CD and other
components, then look at the tables starting on page 49 of
this manual. Make a note of the various codes for each
piece. Note that some TV/VCR combined units may use
VCR codes, not TV codes.
2) Sit in a position in front of your equipment, and make
sure that all components are turned off.
3) In the SETUP mode, press P-PRO and the device labels
will appear.
4) Select the device button you wish to program, then
choose the device table you took the code from. For
example, for a TV, press TV twice. If you want AUX to
control a VCR, press AUX, then press VCR.
5) You can now enter a code using the remote’s keypad,
or UP or DOWN. After the third digit is entered, the remote
transmits a power command. If the component turns on,
press SAVE and then EXIT.
6) If you could not find a code which works, hold the UP
button to step through all the codes in the table for that
device. Release UP when your equipment turns on. If you
go past, press DOWN. Press SAVE and then EXIT.
7) The display will change to show the devices again, still
in the P-PRO mode. Repeat steps 4 to 7 until all your
equipment is working.
8) Press MAIN to return to the main menu from any setup
mode.
9) Test the remote to see which buttons will operate your
equipment. For example, if you were trying to control your
TV, check the power, channel up and down, and volume
up and down. If some of these buttons are not working
correctly, choose another code for that manufacturer, or
you can program over those not working by using the
LEARN mode.
LEARN
The PT-7010A remote can learn commands from other
remote controls. This is useful if the pre-programmed
commands do not operate some of your equipment, if
certain buttons do not work, or you want to customize key
functions. NOTE: PAGE, MAIN, FAV, M1, M2 and M3
cannot be reprogrammed.
Find your original remote and make sure it has good
batteries. You must also make certain it operates your
equipment perfectly. Operate a few commands to ensure
that the buttons you want to program are functioning
properly from that original remote.
In the following example, the Sherbourn remote will learn
the PLAY command from a DVD remote.
1) Point the DVD remote into the Red IR top window of
the Sherbourn remote. Place them on a flat surface, about
1 to 2 inches apart, and avoid bright lighting or sunlight.
2) In the SETUP mode, press LEARN.
3) Select the DVD device button and the display will
change to show some common DVD labels, remembering