Sherbourn Technologies PT-7010A - Manual (Page 26)

26
Overview of the PT-7010A
Remote
• Fully backlit
• Pre-programmed for most brands of A/V equipment
• Learns commands from your other remote controls
• Macro feature lets you program a sequence of control
steps
• Operates up to ten components
• Does not lose programming memory when changing
batteries
Button Layout
Think of the Sherbourn PT-7010A remote control as ten
remotes in one. There are ten DEVICE buttons (five on
either side of the display) and each allows the remote to
operate one piece of equipment. From the factory, the
device buttons are labeled: CD, TAPE, AUX, ZONE2,
7010A, DVD, VCR, SAT, TV and CABLE.
Only the 7010A and ZONE2 buttons are pre-programmed,
and these allow the remote to operate your PT-7010A.
The remote can be set to operate your other remote
controlled equipment.
This is done in three ways from the hidden SETUP menu:
1) Entering a code from the tables at the end of this manual
2) Stepping through the codes
3) Learning from your other remotes
See Remote Setup on page 31 for more details.
1
LCD Display
The top line shows the present device, mode or status,
and it shows when a remote command is being transmitted.
The bottom line shows the page number, status and basic
instructions during programming.
The main part of the display shows the labels of the ten
DEVICE buttons. You can change any label and customize
the remote to fit your system. Note: this is not a touch-
sensitive screen, just a way of labeling the device buttons
on each side, and showing instructions and status.
2
Button and Display Light
The button on the right side of the remote briefly turns on
the lights for the buttons and display. Pressing it again
will turn it off. The duration of time the lights stay on is
adjustable or the lights can be disabled.
Adjusting the LCD Contrast: The contrast of the display
can be changed by holding down the MAIN button and
pressing the Joystick Pad UP or DOWN.
3
DEVICE Buttons
Once you press a device button, all the device buttons
change label and function to become buttons to operate
your device. There are two pages per device, and you can
move between them using the PAGE button.
4
PAGE Button
Use this to jump to various display pages. For example, if
you press the 7010A device button, the display changes to
show buttons which control your PT-7010A. If you press
PAGE, the display will move to page 2, showing more
functions for the PT-7010A