Sherbourn Technologies PT-7010A - Manual (Page 59)

59
Technical Specifications
LINE LEVEL INPUTS
Sensitivity: 125mV for 0.5V output
Frequency Response:
+/- 0.5dB from 20Hz to 20kHz
Signal to Noise Ratio:
(relative to 2V out) Analog 97dB
Digital 105dB
Distortion (THD): <0.03%
Separation (at 1kHz): 70dB
Tone Control: Bass
+/- 10dB
Treble +/- 10dB
AUDIO OUTPUT SECTION
Frequency Response: Main Channels
(Large) 20Hz to 20kHz
Subwoofer (LFE): 20Hz to 160Hz
(Note: The subwoofer crossover is set at
160Hz. The subwoofer plays the bass from the
other channels using the LFE Bass
Management function in the signal processing
formats)
Delay Adjustment:Center 0-25ms
Rear 0-25ms
VIDEO SECTION
Video Inputs/Outputs: 1V p-p, 75&!
Bandwidth Component Video:100MHz, -1.5dB
S-Video: 6MHz, -2dB
Composite Video: 18MHz, -1.5dB
(Video transcoder / up converter circuitry is
completely automatic)
FM TUNER SECTION
FM Range: 87.5 to 108MHz, 0.2MHz steps
Usable FM Sensitivity (Mono): 1.6uV at 75&!
At 75kHz: 15.2dBf (DEV 30dB)
50dB Quieting Sensitivity (Stereo): 31.6uV at 75&!
41.2dBf
Audio Output Bandwidth (+0.5, -3dB):
30Hz to15kHz
AM TUNER SECTION
AM Range: 530 to 1710kHz, 10kHz steps
Usable AM Sensitivity (S/N 30% modulated)
At 20dB S/N: 16uV / (600uV/m)
At 1mV input: 48dB
TRIGGER OUTPUTS
12V MAIN and ZONE 2
Trigger Current load <500mA total
MAIN Zone Trigger Relay Contact Rating:
24VDC at 2A Maximum
XLR OUTPUTS
Pin #1 = Ground
Pin #2 = Positive
Pin #3 = Negative
INFRARED OUTPUTS (OPTICALLY ISOLATED)
1/8" Jacks at 12V level
POWER REQUIREMENTS
120VAC, 60Hz, 40W
DIMENSIONS
Width 17 inches (432mm)
Depth 15-1/2 inches (394mm)
Height 5-3/4 inches (146mm)
SHIPPING WEIGHT
35 pounds (16kg)