Sherbourn Technologies PT-7010A User Manual
Page 9
9
8
AM/FM Tuner Controls
The AM/FM button toggles between the AM or FM band.
Press and hold it to scan of the station presets. Press it
again or press a preset button to stop the scan.
DIRECT Tuner Controls
Press the DIRECT button, then the numbers for frequency
tuning.
UP/DOWN Tuner Controls
Switch to stations above or below the frequency of the
current station. If repeatedly pressed, the tuner will move
up or down one frequency step each time. If held down
for a second or more, the tuner will automatically keep
tuning stations. Press UP or DOWN once again to stop
when it reaches a station you like.
Preset Tuner Memory Buttons
Press just the numbers (do not press DIRECT) for tuning
the memorized presets.
9
Tone Controls
To change the tone, first press BASS or TREBLE and then
press UP or DOWN to suit your taste. The display will
show the change in dB level for reference. The range for
both BASS and TREBLE is +/-10 dB in steps of 1 dB.
The unit returns to its normal display after a few moments
of inactivity, and any level changes are retained. The BASS
and TREBLE levels can also be adjusted using the OSD
TONE Menu and the remote control.
Note: The Tone controls do not affect the LFE channel, or
the 8-Channel analog input.
10
Signal Processing Indicator Lights
DOLBY DIGITAL
This light is on when a Dolby Digital signal is being
decoded.
DTS
This light is on when a DTS signal is being decoded.
DOLBY PRO LOGIC llx
This light is on when the Dolby Pro Logic II or Pro Logic
IIx mode is engaged.
DIGI
This light is on when a digital audio signal is being
decoded.
11
MUTE Button
This turns off the sound. Press it again, or adjust the volume
control to return to the previous volume level.
12
PANEL DIM Button
The front panel lights have four levels: bright, medium,
low and off (low intensity display with all illumination
off).
13
Additional Front Panel Lights
COM/RECV
This light pulses to verify front panel volume LEVEL or
INPUT SELECTOR commands are being sensed, or that
the remote control commands are being sensed.
ZONE TWO POWER
This light is on when Zone 2 is turned on.
ZONE TWO ADJUST
This light is on when Zone 2 is being adjusted.
SIDE AXIS
This light is on when the side-axis outputs are enabled.