Things you should know, User orientation, Hookflash – Samsung iDCS 100 User Manual

Page 114: C.o. lines, Distinctive ringing, System tones

Advertising
background image

3

SYSTEM TONES

The system provides several tones to assist you. Some of these tones are
already familiar to you.

Intercom Dial Tone—A steady tone that indicates you can begin dialing.

DIAL TONE

CONTINUOUS

Ringback Tone—Indicates the station you dialed is ringing.

RINGBACK TONE—1000 ms ON/3000 ms OFF

CONTINUOUS

Busy Tone—Indicates the station you dialed is busy.

BUSY TONE—500 ms ON/500 ms OFF

CONTINUOUS

DND/No More Calls Tone—Fast busy tone indicates the station you
dialed is in the Do Not Disturb mode or cannot receive any more

DND/NO MORE CALLS TONE—250 ms ON/250 ms OFF

FOR TEN SECONDS

Transfer/Conference Tone—Indicates your call is being held and you
can dial another party.

TRANSFER/CONF TONE—100 ms ON/100 ms OFF

CONTINUOUS

Confirmation Tone—Very short beeps followed by dial tone indicate
you have correctly set or canceled a system feature.

CONFIRMATION TONE—50 ms ON/50 ms OFF

FOR ONE SECOND
(programmable)

2

THINGS YOU SHOULD KNOW

USER ORIENTATION

Lifting the handset on your telephone will provide the iDCS system with dial
tone. This is also referred to as internal or intercom dial tone. To get an out-
side line from the telephone company, dial an access code, usually the digit
9.” To call another station in your system, simply dial its extension number.
See your system directory list for other access codes and extension num-
bers.

HOOKFLASH

Throughout this guide, you will see references to “hookflash.” A hookflash is
a momentary operation of the hookswitch required for a feature operation.
Some telephones have a FLASH key. This key may be pressed instead of
the hookswitch.

C.O. LINES

Lines from the telephone company are “C.O. lines.” Calls on these lines are
referred to as “outside calls.” These C.O. lines are accessed by dialing an
access code. For example, dial 9 to get a local outside line or dial 8008XX
for other line groups. Each line in the system is numbered beginning with
701, and then 702, 703, etc. To get a specific line, dial its three digit line num-
ber. If Least Cost Routing (LCR) is programmed into the system, you will only
be required to dial 9.

DISTINCTIVE RINGING

The iDCS system provides distinctive ring patterns to your phone:

• Outside calls have a single ring tone repeated.
• Intercom calls have a double ring tone repeated.
• Door phone calls and alarm/appointment reminders have a triple ring

tone repeated.

HOME PAGE

Table of Contents

Guide-Contents

Advertising