Samsung iDCS 100 - Manual (Page 139)

22 21
PROGRAM PERSONAL SPEED DIAL
NUMBERS FOR OTHER STATIONS
Individual station users can program their own numbers, but in cases where
this is not practical, or for single line telephone users, this program allows a
system administrator to view or change any station’s speed dial numbers.
The station speed dial codes are 00–49. Each station begins with ten num-
bers (00–09) and can be assigned more in blocks of ten (up to a maximum
of fifty numbers).
Each speed dial number consists of a line access code and the telephone
number to be dialed. The access code can be any line group, individual line,
station group or individual extension. The speed dial number can be up to
24 characters long including ✱, #, FLASH and PAUSE.
NOTE: If Least Cost Routing (LCR) is used, the LCR access code must be
entered.
When you are entering a speed dial number, there are some special keys
that you will need to use. These are the bottom row of programmable keys
on the LCD 12B and LCD 24B keysets and are known as keys A, B, C, D, E
and F.
PROGRAM KEYS
UP & DOWN - Scrolls through extension numbers and speed dial bins.
KEYPAD - Used to enter number.
HOLD - Press to clear entry.
A - Does not have a function.
B - Inserts a FLASH.
C - Inserts a PAUSE.
D - Changes the dialing type from pulse to tone.
E - Hides and displays digits.
F - Changes display to speed dial name entry.
DCS KEYSETS
A B C D E F
12 BUTTON KEYSET
PROGRAMMABLE KEYS LAYOUT
A B C D E F
24 BUTTON KEYSET
PROGRAMMABLE KEYS LAYOUT
iDCS KEYSETS
Open customer programming and follow the instructions below.
ACTION DISPLAY
1. Press TRSF and then dial 105 [201] SPEED DIAL
Display shows 00 :
2. Dial the station number (e.g., 205) OR [205] SPEED DIAL
press UP or DOWN to select the station 00 :
and press the right soft key to move the
cursor OR press the left soft key to go
to step 4
3. If the selected station has no speed dial [205] SPEED DIAL
bins, this display will be shown and a new SPDBLK NOT EXIST
station may be selected
4. Dial the location number (e.g., 05) OR [205] SPEED DIAL
press UP or DOWN to select the location 05: _
and press the right soft key to move the
cursor OR press the left soft key to return
to step 2
5. Enter the trunk access code (e.g., 9) [205] SPEED DIAL
followed by the number to be dialed 05 : 9-4264100_
(e.g., 4264100) OR press the right
soft key to return to step 2 OR press the
left soft key to return to step 3 OR press
HOLD to clear an entry (if an error is made,
use the DOWN key to step back)
A C E
Transfer
Speaker
VOLUME
B D F
28D KEYSET, 18D KEYSET
PROGRAMMABLE KEYS LAYOUT
8D KEYSET PROGRAMMABLE
KEYS LAYOUT
Transfer Speaker
A B
C D
E F
HOME PAGE Table of Contents Guide-Contents