Sharp AR-207 - Manual (Page 21)

19
MAKING COPIES
Copying from the original table
1 Turn the power switch on.
● It will take about 35 seconds for the copier to warm up. However, you
can make desired settings and press the START key during warm-up.
Copying will start after warm-up.
● If the copier has been programmed in the auditing mode, the START
key indicator will not light up and “
” will appear in the copy
quantity display. Enter an assigned 3-digit account number. See page
13.
● If an optional printer expansion kit or facsimile expansion kit is
installed, when the power is already on and all indicators except the
POWER SAVE indicator are off, the copier is in the auto power shut-
off mode. Press the START key in this case. See page 58, POWER
SAVE MODES.
2 Place the original face down on the original table. Align
it with the original size scale.
● The ORIGINAL SIZE indicator for the size detected will light up.
● Image loss (max. 5/32" (4 mm)) can occur at the leading and trailing
edges of the copies. Also image loss (max. 5/32" (4 mm) in total) can
occur along the other edges of the copies.
3 Close the document feeder cover.
● Paper matching the size of the original will be automatically selected
when the auto paper select function is enabled. To copy onto paper of
a different size, press the TRAY SELECT key.
● The auto paper select function can be disabled using user program
No. 8. If this function is disabled, use the TRAY SELECT key to
select the desired paper tray. See page 51, USER PROGRAMS.
● The bypass tray cannot be automatically selected.
4 Ensure that the desired paper tray is selected.
COPYING FROM THE ORIGINAL TABLE
Use the original table for copying bound documents and other originals that
cannot be set in the RSPF.
Using the original table
Power on