Sharp AR-207 - Manual (Page 53)

51
GENERAL INFORMA
TION
User programs
USER PROGRAMS
The user programs allow the parameters of certain functions to be set,
changed, or canceled as desired.
List of user programs
This copier has the following user programs.
Program Program name Description
No.
1 Auto clear time Sets the auto clear time. The copier returns to the initial settings
when the auto clear time elapses after the last copy is made.
2 Preheat mode Sets the time that elapses before the copier enters the preheat
mode after any operation is made. See page 58.
3 Auto power shut-off Sets the time that elapses before the copier enters the auto power
timer shut-off mode after any operation is made. See page 58.
4 Stream feeding mode Enables or disables the stream feeding mode. See page 14.
5 Auto power shut-off setting Enables or disables the auto power shut-off mode. See page 58.
6 Border line for 2 in 1 or Enables or disables the border line which is printed in 2 in 1 or 4 in 1
4 in 1 copying. See page 37.
7 Rotation copy Enables or disables rotation of original images. See page 36.
8 Auto paper select mode Enables or disables the auto paper selection. See page 15.
9 Auto tray switching Enables or disables the automatic tray switching which occurs when paper
in a tray runs out. (This switching cannot switch to the bypass tray.)
10 Auditing mode Enables or disables the auditing mode, which controls access to
copier. See page 13.
11 Account number entry Registers accounts for auditing mode.
12 Account number change Changes account numbers for auditing mode.
13 Account number deletion Deletes accounts for auditing mode.
14 Number of copies Displays the total number of copies made against account numbers.
per account
15 Resetting account Resets all audit accounts or resets any desired individual account.
16 Erase width adjustment Sets the amount of the edge erase and center erase areas. See page 39.
17 Layout in 2 in 1 copy Selects a pattern for 2 in 1 copying. See page 37.
18 Layout in 4 in 1 copy Selects a pattern for 4 in 1 copying. See page 37.
19 Offset of paper output tray Enables or disables the offset function of the paper output tray. The offset
function can be specified respectively for the upper and lower areas
separated by an optional job separator tray. See page 27.
20 Image rotation in duplex Enables or disables image rotation (180°) of the front side in one-sided to
copying two-sided copying or two-sided to one-sided copying. See page 22.
22 Location of the margin Selects the location of the expanded margin. See page 41.