Sharp AR-207 - Manual (Page 44)

42
ST
A
TUS
INDICA
T
ORS
1 Open the bypass tray. Lift slightly on the side cover
and slide the cover out until it stops.
2 Push gently on both sides of the front cover to open the
cover.
3 Push the toner cartridge lock release lever and pull the
toner cartridge out. Remove the toner cartridge while
supporting it with the left hand at the green label position.
● For disposal of the old toner cartridge, contact your dealer.
4 Remove the new toner cartridge from the bag. Hold the
cartridge on both sides and shake it horizontally four or
five times.
TONER CARTRIDGE REPLACEMENT
Toner cartridge replacement
Toner cartridge lock
release lever
4 or 5 times
GENUINE SUPPLIES
For best copying results, be sure to use only
SHARP Genuine Supplies which are designed,
engineered and tested to maximize the life and
performance of SHARP copiers. Look for the
Genuine Supplies label on the toner package. When the toner cartridge replacement required ( ) indicator lights up,
replacement of the toner cartridge will be needed soon. Obtain a new
cartridge. When the toner cartridge replacement required (
) indicator
blinks, the toner cartridge must be replaced before copying can be resumed.
Replace the toner cartridge by following the procedure below.
During a long copy run of a dark original, the indicator
may blink and the copier stop, even though toner is left. The
copier will feed toner up to 2 minutes and then the START key
indicator will light up. Press the START key to restart copying.