Siemens 300 H - Manual (Page 64)

Step by Step
Using a different telephone in the same way as your own
64 64 64 64
Identification with the chip card
(optiset E advance only)
Precondition: You have been assigned a chip card by
System Support for logon at other telephones. The tele-
phone at which you wish to log on must be equipped
with a chip card reader (optiset E signature module).
Within your own HiPath 4000 or Hicom 300 E/H system
area:
Insert the chip card. All lamps light up briefly.
"ID card" and the number of the home station are indi-
cated on the display.
or At another HiPath 4000 or Hicom 300 E/H system in
the integrated network:
Insert the chip card.
S
Enter the node code for your own HiPath 4000 or Hi-
com 300 E/H system (enquire with System Support).
SU
Enter your own number and press the square key.
Deactivating identification at the other
telephone
If you logged on with a PIN:
Press the key. The lamp lights up.
MM
Enter the service code.
or
Select and confirm.
Select and confirm.
If you logged on with a chip card:
Remove the chip card when the telephone is in the idle
state.
Insert
chip card
Chip card
reader:
Enter the code!
Service Menu
PIN / COS?
Deactivate PIN?
Identification is deactivated automatically if the
far-end telephone is not used for several minutes.
Remove
chip card
Chip card
reader: