Sony Ericsson PDW-530P - Manual (Page 108)

Cha
pt
er 7
Sa
v
ing an
d Load
ing Us
er Se
tt
ing Dat
a
108
7-2 Saving and Loading Scene Files
If you want to set a file ID for the data to be saved
Set the file ID before going to step 3.
For details on setting the file ID, see “Setting the file
ID” on page 109.
3
Turn the MENU knob to move the b mark to “SCENE
STORE”, and press the MENU knob.
If no “Memory Stick” has been inserted, the SCENE
STORE page appears.
4
Select the desired file number.
When no “Memory Stick” has been inserted
Turn the MENU knob to move the
b mark to the
desired file number, and press the MENU knob.
When the save is completed, the SCENE FILE page
appears again.
When you select a file number where data has
already been saved
The message “OVERWRITE OK? YES
b NO”
appears. In this case, the b mark is placed on the left
of “NO”.
• To stop overwriting, press the MENU knob.
• To overwrite, move the
b mark to “YES” and press
the MENU knob.
When a “Memory Stick” has been inserted
You can use up to 20 pages, from P01 to P20, to save
scene files in the “Memory Stick”. Each page can hold
up to 5 files.
1 Turn the MENU knob until the page which
contains the desired file number appears, then press
the MENU knob.
2 Turn the MENU knob to move the b mark to the
desired file number, and press the MENU knob.
The message “STORE OK? YES
b NO” appears.
3 To carry out the storing, move the b mark to
“YES” and press the MENU knob.
To cancel, press the MENU knob leaving the
b
mark pointing to “NO”.
You can select the contents of the user file to be
displayed on the page.
For details, see “Selecting the display contents” on
page 110.
5
To end the menu operation, set the MENU ON/OFF
switch to OFF or close the cover of the menu operating
section.
To return to the SCENE FILE page
After the message “COMPLETE” is displayed, move
the
b mark to “ESC” at the top right of the page by
turning the MENU knob, then press the MENU knob.
White balance setting data to be saved in
the scene file
The white balance setting data to be saved in the scene file
depends on the setting of the SCENE WHITE DATA item
on the REFERENCE page of the FILE menu.
F04 SCENE FILE
s1 :STANDARD
s2 :STANDARD
s3 :STANDARD
s4 :STANDARD
s5 :STANDARD
sSTANDARD
SCENE RECALL : EXEC
SCENE STORE : EXEC
F.ID:
TOP
?P00 SCENE STORE
DISPLAY MODE : ALL
MEM-01:STANDARD
MEM-02:STANDARD
MEM-03:STANDARD
MEM-04:STANDARD
MEM-05:STANDARD
ESC
P01 SCENE STORE
DISPLAY MODE : ALL
001.SCENE1 FEB/05/02
002.STANDARD
003.STANDARD
004.STANDARD
005.STANDARD
***.5FILE SAVE MEM1-5
ESC
P01 SCENE STORE
STORE OK? YES NO
DISPLAY MODE : ALL
001.SCENE1 FEB/05/02
002.STANDARD
003.STANDARD
004.STANDARD
005.STANDARD
***.5FILE SAVE MEM1-5
ESC
F05 REFERENCE
REFERENCE STORE : EXEC
REFERENCE CLEAR : EXEC
REFERENCE LOAD : EXEC
REFERENCE SAVE : EXEC
F.ID: sssssssssssssssss
SCENE WHITE DATA: OFF