Sony Ericsson PDW-530P - Manual (Page 26)

C
h
apt
er 2
L
oc
at
ions
and
F
un
c
tion
s
of
P
ar
ts
and
Con
tr
ols
26
2-3 Audio Functions
f MONITOR volume control
This control adjusts the speaker or earphone volume for
sounds other than the alarm sound. At the minimum
position, no sound can be heard.
g ALARM volume control
This control adjusts the speaker or earphone alarm volume.
At the minimum position, no sound can be heard.
However, if in the AUDIO-1 page of the
MAINTENANCE menu the MIN ALARM VOL item is
set to”SET”, the alarm tone is audible even when this
volume control is at the minimum position.
ALARM volume control
h Built-in speaker
During recording, the speaker can be used for monitoring
the E-E
1)
sound, and during playback for monitoring
playback sound. The speaker also sounds alarms to
reinforce visual warnings.
The output level of the speaker can be lowered by
changing the setting of the SP ATT LEVEL item on the
AUDIO-1 page of the MAINTENANCE menu.
If you connect an earphone to the EARPHONE jack, the
speaker is automatically muted.
See 9-3 “Operation Warnings” on page 134 for
information about alarms.
1) E-E: Abbreviation of “Electric-to-Electric.” In E-E mode, video and audio
signals input to the camcorder are output after passing through internal
electric circuits only. This can be used to check input signals.
Audio functions (2)
CH-1/2 CH-3/4
switch
position MONITOR
switch
position Audio output
CH-1/2 CH-1 Audio channel 1
MIX Mix sound of channels 1 and 2
CH-2 Audio channel 2
CH-3/4 CH-3 Audio channel 3
MIX Mix sound of channels 3 and 4
CH-4 Audio channel 4
Minimum Maximum
PRESET
SEL/SET
THUMBNAIL
S.SEL
ESSENCE MARK
SHIFT CLIP MENU
SUB CLIP
REGEN
CLOCK
F-RUN
SET
R-RUN
9 LEVEL (CH-1/CH-2) controls
qa AUDIO IN CH-1/CH-2 / CH-3/CH-4 switches
0 AUDIO SELECT CH-1/CH-2 switches
qs LINE / AES/EBU / MIC selectors
qf AUDIO OUT connector
qg AUDIO IN CH1/CH2 connectors
qh DC OUT 12V connector
qd +48 V/OFFf switches