Sony Ericsson PDW-530P - Manual (Page 32)

C
h
apt
er 2
L
oc
at
ions
and
F
un
c
tion
s
of
P
ar
ts
and
Con
tr
ols
32
2-4 Shooting and Recording/Playback Functions
w VIDEO OUT connector (BNC type)
This connector outputs a composite video signal for a
video monitor. With a video monitor connected to this
connector, you can monitor the picture being shot by the
camera or the picture played back by the VDR. To choose
between the composite video signal output and SDI signal
output, use the menu. When synchronizing the time code
of an external VDR with that of the camcorder, connect
this connector to the GENLOCK IN connector of the
external VDR.
By installing the CBK-SD01 extension board (not
supplied), you can output an SDI signal (supporting
embedded audio and the EDH function) from this
connector.
For details on how to select the output signal, see 6-3-2
“Selecting the Output Signals” on page 94.
x REMOTE connector (8-pin)
Connect the RM-B150/B750 Remote Control Unit (not
supplied), which makes it possible to remote-control the
VDR and camera.
y GENLOCK IN connector (BNC type)
• This connector inputs a reference signal when the
camera is to be genlocked or when the time code is to be
synchronized with external equipment. Use the
MAINTENANCE menu to adjust the genlock H-phase
(phase of horizontal sync signal) and the sub-carrier
phase.
For details, refer to the Maintenance Manual.
• This connector also inputs a return video signal. You can
display the image of the return video signal in the
viewfinder screen while holding the RET button down
with “RETURN VIDEO” set to “ON” on the
GENLOCK page of the OPERATION menu.
• This connector also inputs an external analog composite
video signal.
When the CBK-SC01 extension board (not supplied) is
installed, you can record the external analog composite
video signal input to this connector.
z TEST OUT connector (BNC type)
This connector outputs the video signal for a video
monitor. The output signal can be selected to be composite
or RGB. The factory setting is composite, and the setting
returns to composite whenever the power is switched on.
Depending on the internal board and menu settings, the
menu, the time code and the shot data can be superimposed
on the image on the monitor. Like the VIDEO OUT
connector, this connector can also be used to synchronize
the time code of an external VTR with the time code of the
camcorder.
For details on how to select the test output signal, refer to
the Maintenance Manual.
wj (i.LINK) DV IN/OUT S400 connector (6-pin,
IEEE1394 compliant)
Connect to a device supporting the AV/C protocol or SBP
2 protocol, using a DV cable.