Sony Ericsson PDW-530P - Manual (Page 99)

Cha
p
te
r 6
Men
u
Dis
pla
y
s
and
Det
a
iled Se
tt
ing
s
99
6-3 Adjustments and Settings from Menus
5
Turn the MENU knob to move the b mark to the item
you want to set, and press MENU knob.
The b mark on the left of the selected item changes to
a z mark and the z mark on the left of the setting
changes to a ? mark.
6
Turn the MENU knob to display the desired value, and
press the MENU knob.
The z mark on the left of the selected item changes to
a
b mark and the ? mark on the left of the setting
changes to a z mark.
7
To continue the remaining settings, repeat steps 5 and
6.
8
When you finish settings, turn the MENU knob to
move the
b mark to “OK”, then press the MENU knob.
The internal clock is set with the date and time set in
steps 5 to 7. The TIME/DATE page of the
DIAGNOSIS menu appears again. The time set on the
TIME ADJUST setting window is displayed.
To cancel the setting
Before executing step 8, move the
b mark to “ESC” at the
top right of the window and press the MENU knob.
Alternatively, push the CANCEL/PRST / ESCAPE switch
down to the ESCAPE side.
All settings or changes are discarded and the TIME/DATE
page of the DIAGNOSIS menu appears.
6-3-7 Selecting the Lens File
Note
When using a serial lens, lens file selection is not possible.
The LENS FILE page of the USER menu allows you to
change the lens file according to the lens in use.
Proceed as follows.
1
Set the MENU ON/OFF switch to ON.
The last accessed menu page appears on the screen.
2
Turn the MENU knob until the LENS FILE page
appears, then press the MENU knob to select the page.
The LENS FILE page shows the name and the f-stop
(iris setting) of the lens currently selected.
3
Turn the MENU knob to move the b mark to LENS
FILE SELECT, and press the MENU knob.
The b mark on the left of the selected item changes to
a z mark and the z mark on the left of the setting
changes to a ? mark.
4
Turn the MENU knob until the lens file No. in use
appears, then press the MENU knob.
The z mark changes to a b mark and the ? mark on the
left of the lens No. changes to a z mark.
If you do not want to use a lens file
Select NO OFFSET.
5
To end the menu operation, set the MENU ON/OFF
switch to OFF or close the cover of the menu operating
section.
6-3-8 Selecting the Aspect Ratio
The FORMAT page of the OPERATION menu allows you
to select the aspect ratio of the video output signal.
Note
When the CA-701/702/702P camera adaptor is used with
the camcorder, this function is not available. To select the
aspect ratio, disconnect the CA-701/702/702P camera
adaptor from the camcorder or turn off the power of the
CA-701/702/702P camera adaptor.
1
Follow the procedure of steps 1 to 3 described in
6-3-4 “Specifying an Offset for the Auto White
Balance Setting” on page 96 to display the FORMAT
page of the OPERATION menu.
2
Turn the MENU knob to move the b mark to “16:9/4:3
SELECT”, and press MENU knob.
MONTH Sets the month.
DAY Sets the day.
Item Description
U15 LENS FILE
LENS FILE SELECT: 1
F.ID :
TOP
20 FORMAT
16:9/4:3 SELECT : 16:9
SCAN MODE : I
UC/J SELECT : UC