SUPER MICRO Computer SUPERSERVER 6014L-T - Manual (Page 26)

2-8
S UPER S ERVER 6014L-T User's Manual
2-5 Checking the Serverboard Setup
After you install the 6014L-T in the rack, you will need to open the unit to make sure
the serverboard is properly installed and all the connections have been made.
1. Accessing the inside of the system (Figure 2-5)
First, grasp the two handles on either side and pull the unit straight out until it
locks (you will hear a "click"). Next, depress the two buttons on the top of the
chassis to release the top cover. There is a large rectangular recess in the
middle front of the top cover to help you push the cover away from you until it
stops. You can then lift the top cover from the chassis to gain full access to the
inside of the server.
2. Check the CPUs (processors)
You should have one or two processors already installed into the serverboard.
Each processor should have its own heatsink attached. See Chapter 5 for
instructions on processor installation.
3. Check the system memory
Your 6014L-T server system may have come with system memory already
installed. Make sure all DIMMs are fully seated in their slots. For details on
adding system memory, refer to Chapter 5.
4. Installing add-on cards
If desired, you can install an add-on card to the system. See Chapter 5 for
details on installing a PCI add-on card.
5. Check all cable connections and airfl ow
Make sure all power and data cables are properly connected and not blocking
the airfl ow. See Chapter 5 for details on cable connections. Also, check the air
seals for damage. The air seals are located under the blower fan and beneath
the frame cross section that separates the drive bay area from the serverboard
area of the chassis.