SUPER MICRO Computer SUPERSERVER 6014L-T - Manual (Page 48)

5-12
S UPER S ERVER 6014L-T User's Manual
5-9 Connector Defi nitions
NMI Button
The non-maskable interrupt button
header is located on pins 19 and 20
of JF1. Refer to the table on the right
for pin defi nitions.
NMI Button
Pin Defi nitions (JF1)
Pin# Defi nition
19 Control
20 Ground
Power LED
The Power LED connection is located
on pins 15 and 16 of JF1. Refer to the
table on the right for pin defi nitions.
Power LED
Pin Defi nitions (JF1)
Pin# Defi nition
15 Vcc
16 Control
Processor Power Connector
In addition to the Primary ATX power
connector (above), the 12V processor
power connector at PW2 must also
be connected to your power supply
to provide adequate power to the
system.
ATX Power Connector
The main power supply connector on
the X6DPL-EG2 meets the SSI EPS
12V specifi cation. See the table on
the right for pin defi nitions.
Note: You must also connect the
processor power connector (PW2,
below.)
ATX Power 24-pin Connector
Pin Defi nitions (PW1)
Pin# Defi nition Pin # Defi nition
13 +3.3V 1 +3.3V
14 -12V 2 +3.3V
15 COM 3 COM
16 PS_ON 4 +5V
17 COM 5 COM
18 COM 6 +5V
19 COM 7 COM
20 Res (NC) 8 PWR_OK
21 +5V 9 5VSB
22 +5V 10 +12V
23 +5V 11 +12V
24 COM 12 +3.3V
Secondary Power
Connector
Pin Defi nitions (PW2)
Pins Defi nition
1 through 4 Ground
5 through 8 +12V