SUPER MICRO Computer SUPERSERVER 6014L-T - Manual (Page 44)

5-8
S UPER S ERVER 6014L-T User's Manual
5-6 Installing Memory
Note: Check the Supermicro web site for recommended memory modules: http://
www.supermicro.com/support/resources/
CAUTION
Exercise extreme care when installing or removing DIMM modules to
prevent any possible damage.
DIMM Installation (See Figure 5-3)
1. Insert the desired number of DIMMs into the memory slots, starting with DIMM1A
and DIMM1B. Pay attention to the notch along the bottom of the module to prevent
inserting the module incorrectly. (See support information below.)
2. Gently press down on the memory module until it snaps into place. Repeat to
install all DIMMs.
Memory Support
The X6DLP-EG2 supports up to 16 GB of registered ECC DDR2-400 type SDRAM.
The memory scheme is interleaved so you must install two modules at a time.
Note: Due to OS limitations, some operating systems may not support more than
4GB of memory.)
Figure 5-3. Installing DIMMs
To Install: Insert
module vertically
and press down
until it snaps into
place. Pay atten-
tion to the bottom
notch.
To Remove: Use
y o u r t h u m b s t o
gently push each
release tab outward
to free the DIMM
from the slot.
Note: Notches
should align
with their
receptive points
on the slot
Notch Not
Relea
Tab
Release
Tab
DIMM2