SUPER MICRO Computer SUPERSERVER 6014L-T - Manual (Page 55)

Chapter 5: Advanced Serverboard Setup
5-19
VGA Enable/Disable
JPG1 enables or disables the VGA
port on the serverboard. See the table
on the right for jumper settings.
VGA Enable/Disable
Jumper Settings (JPG1)
Jumper Setting Defi nition
Pins 1-2 Enabled
Pins 2-3 Disabled
SMBus to PCI Slots
Jumpers J13 and J15 allow you to con-
nect the PCI-X/PCI slots to the System
Management Bus . The default setting
is open to disable the connection.
See the table on the right for jumper
settings.
SMBus to PCI
Jumper Settings (J13, J15)
Jumper Setting Defi nition
Closed Enabled
Open Disabled
Watch Dog
JWD controls Watch Dog, a system
monitor that takes action when a soft-
ware application freezes the system.
Jumping pins 1-2 will cause WD to
reset the system if an application is
hung up. Jumping pins 2-3 will gen-
erate a non-maskable interrupt signal
for the application that is hung up.
See the table on the right for jumper
settings. Watch Dog can also be
enabled via BIOS.
Note: When enabled, the user needs
to write their own application software
to disable the Watch Dog Timer.
Watch Dog
Jumper Settings (JWD)
Jumper Setting Defi nition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
Power Force On
Jumper JPF allows you to enable or
disable the Power Force-On function.
If enabled, power will always stay on
automatically. If disabled (the default
setting), the user must press the power
button to power on the system.
Power Force-On
Jumper Settings (JPF)
Jumper Setting Defi nition
Open Disabled
Closed Force Pwr On