SUPER MICRO Computer SUPERSERVER 6014L-T - Manual (Page 38)

5-2
S UPER S ERVER 6014L-T User's Manual
1. Remove the protective fi lm from
the heatsink bracket.
2. Locate the heatsink bracket
mounting holes on the reverse side
of the serverboard.
3. Align the four pins of the heatsink
bracket with the four bracket
mounting holes on the back of the
serverboard.
4. Insert the pins of the bracket into
the corresponding mounting holes.
Gently press the bracket onto the
serverboard until it is fully inserted
into the holes.
Heatsink bracket
mounting holes
Remove the pro-
tective fi lm
5-2 Serverboard Installation
This section explains how to mount the X6DLP-EG2 into the SC811LT-260 chassis.
Following the steps in the order given will eliminate the most common problems
encountered in such an installation. To access the inside of the server, remove the
screws from the back lip of the top cover of the chassis, then pull the cover off.
Note: Before you install the serverboard you should fi rst attach the heatsink brackets
to the back of the serverboard.
Installing the Heatsink Brackets
Carefully mount the serverboard to the chassis by aligning the board holes with the
raised metal standoffs that are visible on the serverboard tray. Insert screws into all
the mounting holes on your serverboard that line up with the standoffs and tighten
until snug (do not screw them in too tightly). Metal screws provide an electrical
contact to the serverboard ground to provide a continuous ground for the system.
Installing the Serverboard