Sherwood P-965 - Manual (Page 19)

ENGLISH
19
LOADING BATTERIES
OPERATING COMPONENTS WITH REMOTE CONTROL
1
2
• When operating a Sherwood CD player or tape deck
using the system remote control, aim the remote
control at the REMOTE SENSOR on this unit.
• However, in case of Sherwood DVD player or TV,
aim it at the REMOTE SENSOR on the
corresponding component.
In case of selecting a function on the page menu of
the selected device.
• Find a function with pressing the PAGE button
repeatedly and then press the button corresponding
to the desired function.
Example) when selecting a function on the AUD 1’s
page menu.
STANDBY POWER ON
MAIN PAGE FAV
MUTE
CH. SET VOL
RETURN
DISP
MI
OSD/MENU
1 STEREO
CH/ ADJUST
2 3
4 5 6
7 8 9
0 ENT
M2 M3
DSP DECODE DSP
RNC-510
REMOTE CONTROL OPERATION RANGE
• Use the remote control within a range of about 7
meters (23 feet) and angles of up to 30 degrees
aiming at the remote sensor.
Remove the cover.
Load four alkaline batteries (“AAA” size,
1.5V) matching the polarity.
• When the remote control does not operate or “LOW
BATTERY” is displayed on the LCD screen, etc., the old
batteries should be replaced.
Enter the setup code of the components
respectively, referring to “ENTERING A
SETUP CODE” (page 20).
Turn on the components you want to
operate.
1
Select the device on the main menu of the
remote control corresponding to the
component you want to operate.
2
Press the button corresponding to the
operation you want while aiming the
remote control at the REMOTE SENSOR
on the component.
3
4
Example) When selecting “AUD 1” or “AUD 2” to
operate this unit.
• Then the page menu of the selected device will be
displayed.
The device selected presently
STANDBY POWER ON
MAIN
AUD1 AUD2
CD TV
DVD VCR
TAPE SAT
AUX CABLE
AUD1
Functions on the page 1 Functions on the page 2
AUD1
VID6 7.1IN
DTS PL2MV
DOLBY PL2MS
PCM NOE6C
MPEG NEO6M
PAGE2
AUD1
TUNER VID1
CD VID2
T.MON VID3
AUX VID4
PHONO VID5
PAGE1