Setting the room2 feed setup, English, When selecting the volume mode – Sherwood P-965 User Manual
Page 64
ENGLISH
64
• The ROOM 2 function allows enjoying one source in the main room while playing another in a different room at the same time.
• The analog signals from the 8 CH DIRECT inputs and TAPE MONITOR INs cannot be output from the VIDEO 2 / ROOM 2
(audio) OUTs.
• Each time these buttons are pressed, the volume mode
changes as follows:
Variable : Select this when an power amplifier is connected
to the VIDEO 2/ROOM 2(audio) OUTs for ROOM
2 source playback. You can adjust the ROOM 2
volume level with the MASTER VOLUME
CONTROL knob of this unit or the VOLUME
UP/DOWN buttons on the remote control.
Fixed : Select this when an integrated amplifier, etc. is
connected to the VIDEO 2/ROOM 2(audio) OUTs.
You can adjust the ROOM 2 volume level on the
connected integrated amplifier, etc.
Notes :
• In case that an integrated amplifier, etc. is connected to the VIDEO 2/ROOM 2(audio) OUTs and the volume
mode is set to Variable, if the ROOM 2 volume level is adjusted to high level on both this unit and the connected
amplifier, the ROOM 2 speaker and the connected amplifier may be damaged.
Therefore, be sure to set the volume mode to Fixed for safe operation when using amplifier with its own volume
control for ROOM 2.
• When selecting the Fixed mode, first adjust the volume level as desired in the Variable mode and select the Fixed
mode. Then the volume level will be fixed to the adjusted level.
R E T U R N : B a c k , : S e l e c t
R O O M 2 F E E D S E T U P
V O L U M E MO D E :
R O O M 2 F E E D :
T U N E R
V I D E O 1
C D
V I D E O 2
A U X
V I D E O 3
P H O N O
V I D E O 4
V I D E O 5
V I D E O 6
Off
Variable
To select the desired volume mode.
To select the desired ROOM 2 source.
Press the CURSOR UP(
)/DOWN(
) buttons to select the VOLUME MODE.
1
Press the CURSOR LEFT(
)/RIGHT(
) buttons to select the desired volume mode for the ROOM 2
source.
2
SETTING THE ROOM2 FEED SETUP
STANDBY
POWER ON
MAIN
PAGE
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP
RNC-510
When selecting the VOLUME MODE
STANDBY
POWER ON
MAIN
PAGE
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP