English – Sherwood P-965 User Manual
Page 33
ENGLISH
33
Adjust the level of the selected channel as
desired.
2
Repeat the above steps
and
to adjust
each channel level.
3
• Each time this button is pressed, the parameter changes and is
displayed for several seconds as follows;
Panorama mode(“PANORAMA”, default value : OFF)
This mode extends the front stereo image to include the
surround speakers for an exciting “wraparound” effect with
side wall imaging. Select “OFF” or “ON”.
Center width control(“C-WIDTH”, default value : 0)
This adjusts the center image so it may be heard only from the
center speaker, only from the left/right speakers as a phantom
image, or from all three front speakers to varying degrees.
The control can be set in 8 steps from 0 to 7.
Dimension control(“DIMENSION”, default value : 0)
This gradually adjusts the soundfield either towards the front
or towards the rear. The control can be set in 7 steps from -3
to +3.
Adjusting the Dolby Pro Logic IIx / Dolby Pro Logic II Music parameters
Press the DOLBY PL II MUSIC PARAMETER button to select the desired parameter.
1
Repeat the above steps
and
to
adjust other parameters.
3
At the desired parameter, adjust it as desired.
2
• When selecting either the Dolby Pro Logic IIx Music mode or the Dolby Pro Logic II Music mode depending on
whether “S/B CH” is set to “None” or not, you can adjust the various surround parameters for optimum surround
effect.(Refer to “When selecting the SPEAKER CONFIGURATION” on page 44.)
• In case of PL IIx MUSIC mode, only when original surround mode is “BYPASS” mode or 2 channel digital
signals from Dolby Digital sources, etc. are input, these parameter settings affect the surround effects.
• If the parameter display disappears, start from the
step
again.
STANDBY
POWER ON
MAIN
PAGE
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP
RNC-510
or
CH/
ADJUST
or
STANDBY
POWER ON
AUD2
SLEEP
D/A
DIMM
S.A/B
ROOM2
SUR.B
T.TON
PURE
OSD
PARA.
PAGE1
STANDBY
POWER ON
MAIN
PAGE
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP
RNC-510
or
DOWN
UP
CH/
ADJUST