English, When selecting the digital re-mastering, When the dc trigger 2 mode is set to on – Sherwood P-965 User Manual
Page 56: Continued
56
ENGLISH
• Each time these buttons are pressed, the digital re-
mastering mode changes as follows:
On : Select this to process the input signal digitally and to
convert its sampling frequency to 192 kHz for an
more detailed sound reproduction.
Off : Select this to cancel the digital re-mastering function.
STANDBY
POWER ON
MAIN
PAGE
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP
RNC-510
Press the CURSOR UP(
)/DOWN(
) buttons to select the DIGITAL RE-MASTERING.
1
Press the CURSOR LEFT(
)/RIGHT(
) buttons to select the desired mode.
2
When selecting the DIGITAL RE-MASTERING
Notes :
• The digital re-mastering function does affect on the front left and right signals only.
However, it does not affect on the digital signals that are output from the DIGITAL OUTs of this unit.
• When the stereo mode or the pure audio function is selected while playing analog stereo sources, the digital re-
mastering function cannot be activated.
STANDBY
POWER ON
MAIN
PAGE
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP
• Each time the CURSOR CONTROL buttons are
pressed, “
” is moved to the corresponding input
source.
When the ENTER button is pressed at the desired
input source, “+” is marked it with.
• When the input sources marked with “+” on this
menu are selected with the AUDIO and VIDEO
SELECTOR buttons, etc.,the DC trigger function is
automatically activated. (For details, refer to
“CONNECTING DC TRIGGER OUTs” on page 11.)
• When the ENTER button is pressed at the input
source marked with “+”, “+” is cleared and the DC
trigger 2 function is canceled for this input source.
• Repeat this step until the desired input sources are all
selected.
Press the CURSOR UP(
)/DOWN(
)/LEFT(
)/RIGHT(
) buttons to select the desired input
source that uses the DC trigger 2 function, then press the ENTER button.
3
When the DC TRIGGER 2 mode is set to On
STANDBY
POWER ON
MAIN
PAGE
FAV
MUTE
CH.
SET
VOL
RETURN
DISP
MI
OSD/MENU
1
STEREO
CH/
ADJUST
2
3
4
5
6
7
8
9
0
ENT
M2
M3
DSP
DECODE
DSP
RNC-510
Continued