Sherwood P-965 - Manual (Page 47)

47
ENGLISH
Note :
• When “S/B CH” is set to “2 CH” on the SPEAKER
CONFIGURATION menu, the SUBWOOFER
cannot be selected.
• Depending on your subwoofer type , you can select
one of following types.
ACTIVE: Select this when connecting the powered
subwoofer to “SW” of PREOUT jacks.
PASSIVE: Select this when connecting the subwoofer
without built-in amplifier to “SURROUND
BACK RIGHT” terminals of the power
amplifier.
Note :
• If “SUBWOOFER” is set to “PASSIVE”, the
SURROUND BACK RIGHT channel of the PREOUT
jacks is automatically changed to SUBWOOFER
channel.
Press the CURSOR UP( )/DOWN( )
buttons to select the SUBWOOFER.
1
Press the CURSOR LEFT( )/RIGHT( )
buttons to select the desired mode.
2
When selecting the SUBWOOFER
STANDBY POWER ON
MAIN PAGE FAV
MUTE
CH. SET
VOL
RETURN
DISP
MI
OSD/MENU
1 STEREO
CH/ ADJUST
2 3
4 5 6
7 8 9
0 ENT
M2 M3
DSP DECODE DSP
STANDBY POWER ON
MAIN PAGE FAV
MUTE
CH. SET VOL
RETURN
DISP
MI
OSD/MENU
1 STEREO
CH/ ADJUST
2 3
4 5 6
7 8 9
0 ENT
M2 M3
DSP DECODE DSP
RNC-510
• When the subwoofer without built-in amplifier is
connected to “SURROUND BACK RIGHT”
terminals of the power amplifier, you should set
“SUBWOOFER” to “PASSIVE”.
Press the CURSOR LEFT( )/RIGHT( )
buttons to select the desired mode.
6
• Each time these buttons are pressed, the virtualization
mode changes as follows:
WIDE: This mode expands the front channel sound
field.
REFERENCE: This is the standard mode.
Notes :
• When “WIDE” is selected as virtualization mode,
you can select “2-SPEAKER”, “3-SPEAKER”, “4-
SPEAKER” or “5-SPEAKER”.
• When “REFERENCE” is selected as virtualization
mode, you can select “2-SPEAKER” or “3-
SPEAKER” only.
Press the CURSOR UP( )/DOWN( )
buttons to select the virtualization mode.
5
STANDBY POWER ON
MAIN PAGE FAV
MUTE
CH. SET
VOL
RETURN
DISP
MI
OSD/MENU
1 STEREO
CH/ ADJUST
2 3
4 5 6
7 8 9
0 ENT
M2 M3
DSP DECODE DSP
RNC-510
STANDBY POWER ON
MAIN PAGE FAV
MUTE
CH. SET
VOL
RETURN
DISP
MI
OSD/MENU
1 STEREO
CH/ ADJUST
2 3
4 5 6
7 8 9
0 ENT
M2 M3
DSP DECODE DSP