Sherwood P-965 - Manual (Page 58)

ENGLISH
58
When selecting the DECODING MODE, SURROUND MODE, DYNAMIC RANGE
• Each time these buttons are pressed, “ ” and “ ” are
moved to the corresponding mode.
• Each time these buttons are pressed, the modes change as
follows according to the selected item :
When DECODING MODE is selected
• Depending on the input digital signal format, you can select the desired decoding mode.
AUTO : Select this for automatic detection of a digital input signal format.
The input digital signal format (DTS, Dolby Digital, MPEG or PCM(2 channel stereo), etc.) used by the
selected digital input source is detected automatically to perform the necessary decoding process for
optimum surround modes.
DOLBY DIGITAL : Select this for Dolby Digital signal processing. The decoding process is preformed only when
Dolby Digital signals are input.
DTS : Select this for DTS signal processing. The decoding process is performed only when DTS signals are input.
MPEG : Select this for MPEG signal processing. The decoding process is performed only when MPEG signals are
input.
PCM : Select this for PCM signal processing. The decoding process is performed only when PCM signals are input.
Notes :
• Surround sound effect will not work properly if the signal passes through a graphic equalizer.
Please refer to your equalizer operating instructions for guidance on switching off(or defeating) the equalizer.
• Only when the digital input is selected as signal input for the input sources except PHONO, TUNER and TAPE
MONITOR, the decoding mode can be selected.
• Noise may be generated at the beginning of playback and while searching during DTS playback in the auto mode.
In this case, try playing in the DTS mode.
Notes :
• Only when the digital input is selected as signal input, the decoding mode and the surround mode can be both selected as
desired.
• When the analog input is selected, only the surround mode can be selected as desired.
• When the 8 CH DIRECT is selected as an input source, you cannot perform the surround setup.
STANDBY POWER ON
MAIN PAGE FAV
MUTE
CH. SET VOL
RETURN
DISP
MI
OSD/MENU
1 STEREO
CH/ ADJUST
2 3
4 5 6
7 8 9
0 ENT
M2 M3
DSP DECODE DSP
STANDBY POWER ON
MAIN PAGE FAV
MUTE
CH. SET
VOL
RETURN
DISP
MI
OSD/MENU
1 STEREO
CH/ ADJUST
2 3
4 5 6
7 8 9
0 ENT
M2 M3
DSP DECODE DSP
RNC-510
To select the desired decoding mode.
To select the desired surround mode.
To select the desired Dolby surround mode.
To adjust the dynamic range as desired.
To adjust the PL IIx MUSIC PARAMETER as desired.
S U R ROU N D S E T U P
R E T U R N : B a c k , : S e l e c t
D E C O D I N G M O D E :
S U R R O U N D M O D E :
D O L B Y D I G I T A L E X
+ N O N E
D Y N A M I C R A N G E : 0 . 0
P L I I x M US I C P A R A M E T E R A U T O
Press the CURSOR UP( )/DOWN( ) buttons to select the desired item.
1
Press the CURSOR LEFT( )/RIGHT( ) buttons to select the desired mode.
2
SETTING THE SURROUND SETUP