Sega WaveRunner GP - Manual (Page 102)

www.seuservice.com 93
POINT CONVERGENCE ADJUSTMENT
In the POINT CONVERGENCE adjustment, each of red, green and blue images is partially
moved for color matching. The adjustment may be necessary when the Game Board is replaced or
changed, or screen size is changed. Be sure to perform automatic color matching before starting
the adjustment.
Press the WRITING button (for storing and finish).
TEST MODE WRITING
POSITION
ADJUST
SELECT
RESET
R B G
PIC-ADJ
SET
P
ADJUST MODE
ADJUST MODE
ADJUST MODE
ADJUST MODE
ADJUST MODE
ADJUST MODE
WRITING
Keep pressing the TEST button for
approximately 3 seconds.
The screen changes to ADJUST
mode from the Game mode and
displays the green test pattern.
Using either R or B button, select the desired color
to be adjusted. Note 2 By using the G button, the
green color can also be selected.
The selected color is displayed by
superimposing on green. The
MARKER will be in the color
selected.
The MARKER moves in the
direction of the button's arrow.
However, the movable point is
predetermined.
Although the direct vicinity of the
MARKER's center moves most
conspicuously, make adjustment
by paying attention to the periph-
ery area also. Shown left is the
magnified MARKER periphery.
WRITING is displayed and the
adjustment data is stored. After the
data is stored, the Game Board
screen returns.
If the test pattern is not displayed in
the periphery of the screen, adjust-
ments can be made by pressing the
SELECT button to superimpose the
test pattern and the Game Board's
CRT test screen.
Press the SELECT button as necessary to
superimpose Game Board images.
Note 3
Make adjustment by using the
ADJUST buttons.
The crosshatch test pattern appears
and the MARKER indicating the
adjustment point is displayed.
By using the ADJUST buttons,
move the MARKER to the position to be adjusted.
Press the MODE button twice to have the POINT
ADJUSTMENT mode.
Note 1
MARKER
DO NOT
PRESS.
Note 1 When the MODE button is repeatedly
pressed, the adjustment modes will
circulate as follows:
STATIC ADJUSTMENT MODE
LINE ADJUSTMENT MODE
POINT ADJUSTMENT MODE
Note 2 When either of the COLOR SELECT
buttons (R, B) is pressed, if the desired
color to be adjusted disappears, press
that particular button again.
Note 3 By repeatedly pressing the SELECT
button, only the Projector's TEST
pattern screen and the screen
superimposing the Game Board Test
pattern can be alternately displayed.
1
2
3
4
5
6
7