Sega WaveRunner GP - Manual (Page 85)

www.seuservice.com 76
Moving the Volume Bracket causes Adjust Gear mesh to be disengaged.
Adjust gear mesh and tighten the 2 Nuts.
Grip the Throttle Lever and check to ensure that the V. R. value variations are within the
rotatable range of the Volume Shaft.
After finishing adjustments, be sure to perform Throttle Volume setting on the Volume Setting
screen in the Test mode (see 9 - 3e).
Turn the power off.
Perform the above adjustment procedure ~ .
Disconnect the connector connected to the Throttle Volume. (PHOTO 12. 1 d)
Take out the 2 Nuts which secure the Volume Bracket, and remove the Volume Bracket with
the Volume as is attached.
Remove the Volume Gear from the Volume Shaft, and replace the Volume by removing from
the Bracket.
After the replacement, perform Volume Setting in the Test mode (see 9 - 3e).
THROTTLE VOLUME
220-5373,5484
CONNECTOR (1)
BLACK 3P
PHOTO 12. 1 d
REPLACING THE THROTTLE VOLUME
5
6
7
8
1
2
3
4
5
6
1 3