Sega WaveRunner GP - Manual (Page 50)

www.seuservice.com 41
INPUT TEST
HANDLE BAR 0H
ROLL 0H
THROTTLE LEVER FFH
PITCH 0H
START OFF
VIEW OFF
SAFETY SENSOR OFF
SERVICE OFF
TEST OFF
PRESS TEST AND SERVICE BUTTON TO EXIT
INPUT TEST
When INPUT TEST is selected, the following screen appears on the monitor. The screen
allows the status of each SW and the value of each V.R. of the cabinet to be viewed.
On this screen, periodically check the status of each switch & V.R.
• By pressing each switch, if the display on
the right-hand side of the name of each
switch changes to ON from OFF, the SW
and the wiring connections are satisfactory.
• When checking the SAFETY SENSOR, be
sure to intercept the 3 Sensors on the step.
• Simultaneously pressing the Service button
and the Test button returns the Game Test
Menu screen.
The standard values for adjusting each V. R. are as follows:
In this product, the item of VOLUME SETTING allows V. R. values except for PITCH to be
set.
HANDLE BAR: 8 0 H + 9 (centering position)
ROLL: 8 0 H + 9 (centering position)
THROTTLE LEVER: e 0 H + 9 (lever released)
PITCH:
Over 7 0 H (When the Ride is lowered) ~ Under e 0 H (When the Ride is
raised)
FIG. 9. 3 b a INPUT TEST Screen
LIGHT EMITTER
LIGHT RECEIVER
LIGHT RECEIVER
LIGHT EMITTER
LIGHT RECEIVER
LIGHT EMITTER
FIG. 9. 5 b SAFETY SENSOR