Kodak 5500 - Manual (Page 28)

Chapter 2
1 Press Menu to display the Main Menu.
2 Press
b
until Reset All Settings is selected.
3 Press OK.
Fax Connections
After completing all steps in the Setup Poster, use the instructions in this section to connect the fax feature
of your Kodak EasyShare AiO.
DSL Line
If you have Digital Subscriber Line (DSL) service through your phone company, use the instructions in this
section to connect a DSL filter between the telephone wall jack and your Kodak EasyShare AiO. This filter
removes the digital signal that would block your EasyShare AiO from communicating properly with the
telephone line.
CAUTION
If you have a DSL line and do not connect the DSL filter, you will not be able to send and receive
faxes with your EasyShare AiO.
1 Obtain a DSL filter from your DSL provider.
2 Connect the phone cord supplied with your Kodak EasyShare AiO to the open port on the DSL filter and
the port labeled 1-LINE.
3 Connect the DSL filter cord to the telephone wall jack.
PBX or ISDN Line
If your telephone line has a PBX system, make sure you dial the number for an outside line before dialing
the fax number.
CAUTION
Many digital PBX systems include a call-waiting tone that is factory-set to On. This call-waiting
tone will interfere with any fax transmission, and you will not be able to send or receive faxes
with your Kodak EasyShare AiO. You can disable call-waiting from the AiO Home Center.
If you are using either a PBX or an ISDN converter, make sure the EasyShare AiO is connected to the port
that is designated for fax and phone use.
Some ISDN systems allow you to configure the ports for specific phone equipment—for example, you
might have assigned one for telephone and Group 3 fax and another for multiple purposes.
24 Kodak EasyShare 5500 AiO