KTI Networks NS-32LB451A11 - Manual (Page 9)

3
www.insigniaproducts.com
Power source
Operate your TV/Blu-ray combo only from the type
of power source indicated on the marking label. If
you are not sure of the type of power supplied to
your home, consult an electrician or your local
power company.
Cautions
Damage requiring service
Unplug this TV/Blu-ray combo from the power
outlet and refer servicing to qualified service
personnel under the following conditions:
• When the power supply cord or plug is damaged
or frayed.
• If liquid has been spilled or objects have fallen
into your TV/Blu-ray combo.
• If your TV/Blu-ray combo has been exposed to
rain or water.
• If your TV/Blu-ray combo does not operate
normally by following the operating instructions.
Adjust only those controls that are covered by the
operating instructions because incorrect
adjustment of other controls may result in
damage and will often require extensive work by
a qualified technician to restore your TV/Blu-ray
combo to its normal operation.
• If your TV/Blu-ray combo has been dropped or
damaged in any way.
• When your TV/Blu-ray combo exhibits a distinct
change in performance.
Outdoor antenna grounding
If an outside antenna or cable system is connected
to your TV/Blu-ray combo, make sure that the
antenna or cable system is grounded to provide
some protection against voltage surges and
built-up static charges. Article 810 of the National
Electrical Code, ANSI/NFPA No. 70, provides
information with respect to correct grounding of
the mast and supporting structure, grounding of
the lead-in wire to an antenna discharge unit, size
of grounding conductors, location of the
antenna-discharge unit, connection to grounding
electrodes, and requirements for the grounding
electrode.
Note to CATV system installer
Article 820 of the National Electrical Code,
ANSI/NFPA No. 40 provides guidance for correct
grounding. Specifically, it states that the cable
ground must be connected to the grounding
system of the building as close to the point of cable
entry as practical.
Condensation
Moisture will form on the TV/Blu-ray combo if the
TV/Blu-ray combo is brought from cool
surroundings into a warm room or if the
temperature of the room rises suddenly. When this
happens, the TV/Blu-ray combo's performance may
be impaired. To prevent this, let the TV/Blu-ray
combo stand in its new surroundings for about an
hour before switching it on, or make sure that the
room temperature rises gradually.
Condensation may also form during the summer if
the TV/Blu-ray combo is exposed to the breeze from
an air conditioner. In such cases, change the
location of the TV/Blu-ray combo.
Mobile telephone warning
To avoid interference with your TV picture and
sound, operating problems, or even damage, keep
your cordless and cellular telephones away from
the TV/Blu-ray combo.
End of life directives
Your TV/Blu-ray combo contains tin-lead solder and
a fluorescent lamp containing a small amount of
mercury. Disposal of these materials may be
regulated for environmental reasons. Your
TV/Blu-ray combo also contains material that can
be recycled and reused. For disposal or recycling
information, contact your local authorities or the
Electronic Industries Alliance at www.eia.org to find
a recycler in your area.
Non-active pixels
The LCD panel contains almost 3 million thin film
transistors, which provide exceptionally sharp video
quality. Occasionally, a few non-active pixels may
appear on the screen as a fixed blue, green, or red
point. These non-active pixels do not adversely
affect the performance of your TV/Blu-ray combo,
and are not considered defects.
Antenna lead-in wire
Grounding clamp
Antenna discharge unit
Grounding conductors
Ground clamps
Power service grounding electrode system
Electric service equipment
2
1
3
4
5
6 7
1
2
3
4
5
6
7
Warning
To prevent the spread of fire, keep candles or open
flames away from this product at all times.