Kodak I1400 - Manual (Page 24)

A-61550 May 2007 19
Verifying your
scanner installation
Kodak provides a test application called the Kodak Scan Validation
Tool. This section describes how to use this tool to perform a basic scan
function which includes feeding paper and viewing captured images on
your PC.
The following steps help you to verify that your scanner installation was
successful. If this procedure is successful, you will be ready to use your
scanner. If it is not successful, go back and review the installation
procedures outlined in the section entitled, “Installing the scanner” in
Chapter 2.
Before you begin, be sure the scanner is on and ready to scan.
1. Select Start>Programs>Kodak>Document Imaging>Scan
Validation Tool or click the Scan Validation Tool icon.
The Scan Validation Tool dialog box will be displayed.
2. Select TWAIN (or ISIS) for the Driver Types and Kodak Scanner
i1410/i1420/i1440 as the driver. The Scan Validation Tool dialog box
will be displayed.
NOTE: For a description of this window and toolbar buttons, see
the section entitled, “Scan Validation Tool dialog box” in
Chapter 4.
3. Click one of the window icons to open and display the scanned
images.
4. Click the Setup icon.