Kirby Morgan 37 - Manual (Page 49)

116
© Copyright 1970-2008 Kirby Morgan Dive Systems, Inc. All rights reserved. Document # 080508001
Kirby Morgan 37 & 57
7.12.7 SuperFlow 450 Regulator Installation
Required Tools:
11/16 inch Open-end Attachment on Torque
Wrench
7/8 inch Open-end Wrench, Torque Wrench and 1
3/8 inch Socket
1 /4 inch Flat Blade Attachment on Torque Screw-
driver
1) Install the tie wrap on the center section of the
exhaust whisker, named the exhaust main body and
tighten.
2) Install the spacer on the regulator tube and install
the regulator assembly and spacer on the helmet.
Install the tie wrap on the regulator.
Be sure to install the spacer on the regulator tube.
Install the o-ring that mounts on the regulator tube
inside the helmet.
Install the regulator mount nut.