Logical Solutions Secure Console Servers SCS-R - Manual (Page 28)

Installation
SCS160 / SCS320 / SCS480 Page 28 www.thinklogical.com
SCS160R / SCS320R
Figure 3.5 Replacing an AC Module (Left Module shown partially removed)
Note
To remove the AC Module, you only need to loosen the one captive
screw on the Module. You do not need to remove the chassis from
your rack, or remove the cover of the chassis for any reason. The
photo above shows the cover removed for clarity only.
Insert the replacement Power Module in its place (it will require a slight amount of
force to insert), and tighten the screw. After the screw is tightened, reconnect the IEC
cordset to the Module, and then you can turn the switch on the Module to the On (I)
position. When proper power is restored, the front panel display indicating a module
has failed will clear after a few moments.