System administration, 1 display mode parameters – Logical Solutions Secure Console Servers SCS-R User Manual
Page 58
System Administration
SCS160 / SCS320 / SCS480
Page 58
www.thinklogical.com
SCS160R / SCS320R
Figure 7.2 Default ‘Normal’ Front Panel Display,
The front panel will display system messages (e.g., during reboot or save events)
but will return to the ‘normal’ display after these events are done.
Note
The Edit Mode can be disabled, and the front panel display’s normal
display can also be changed.
The default setting allows the editing of the IP address information using the front
panel buttons. This can be disabled to prevent unauthorized changes.
7.7.1 Display Mode Parameters
The various LCD Display modes are controlled by the entries maintained in
the
/etc/sysconfig/lsi
directory for the following files:
LCD_LINE_1=
LCD_LINE_2=
LCD_DISPLAY_SETTING=
•
LCD_LINE_1= and LCD_LINE_2= allows text entry of up to 24 charac-
ters to be displayed.
•
LCD_DISPLAY_SETTING= can be set to EDIT (default), VIEW, or OFF.
7.7.1.1 Edit
The Edit mode (
LCD_DISPLAY=EDIT
) allows the front panel display to normally
show the current Display information, and allows anyone to use the front panel display
to change the network parameters (IP Address, Net Mask, and Gateway).
7.7.1.2 View
The View mode (
LCD_DISPLAY=VIEW
) allows the front panel display to show
the current information, but disables the editing using the front panel buttons. This
prohibits unauthorized changes to your network settings from the front panel.
scs.localdomainname
Tue Mar 18 15:53:03 2003