Logical Solutions Secure Console Servers SCS-R - Manual (Page 67)

tel (203) 647-8700 Page 67 Product Manual - MAN-000001C
User Setup S
ECURE
C
ONSOLE
S
ERVERS
8 Administering Users
The following commands are used to change settings for Users. You can define as
many Users as you wish, up to the memory capacity of the system. The limiting factor
when it comes to Users is not the number of users but rather the number of simulta-
neous sessions invoked by any number of users (250 sessions maximum).
8.1 User Setup
Each user account must have a unique name, and each has its own password. Each
User account has the following parameters:
Parameter Constraints
name A unique user name made up of contiguous characters. Cannot
be renamed. This name will be displayed at the command
prompt when a user has logged in.
password Linux password for this user account.
port range or
port group
(used below) Default is set to access all ports in the SCS chassis (1-16, 1-32
or 1-48). Ports can be assigned individually (1), in a contiguous
range (2-7), in random ports (3,6,9,15) or any combination of the
above (1,4-7,12,15-16) of valid port numbers for that chassis.
ESCAPE_SEQ Escape sequence. Default is “Esc-A”. Displayed in ASCII (x1bA)
BREAK_SEQ Break sequence. Default is “Esc-B”. Displayed in ASCII (x1bB)
ALLOW_CLEAR Range or group of Ports for which this User account can Clear
the Port Buffers.
ALLOW_CONNECT Range or group of Ports to which this User account can connect
ALLOW_MONITOR Range or group of Ports which the User can monitor