Lucent Technologies 6 - Manual (Page 36)

32 Issue 1 CRCS R6.0 April 1999
Faxmodem Installation
Faxmodem Installation
To use CRCS fax options, one or more faxmodems must be properly installed and
configured. The type of faxmodem recommended by Lucent Technologies
depends on operating system used for CRCS—Microsoft Windows 95 or
Microsoft NT 4.0.
When installing a faxmodem on a CRCS PC that manages two MCUs, connect to
COM3 or COM4. This requires either an internal modem or an external modem
Windows 95
The following faxmodem recommendations are for Microsoft Windows 95 sys-
tems:
n US Robotics Sportster 33.6 Faxmodem (internal or external)
n Puredata SatisFAXtion 400/400e Faxmodem (only recommended for
upgrades of CRCS)
Windows NT 4.0
The following faxmodem recommendations are for Microsoft Windows NT 4.0 sys-
tems:
n US Robotics Sportster 33.6 Faxmodem (internal or external)
n Zoom Faxmodem VFX28.8 (only recommended for upgrades of CRCS)
n Multitech MT1932ZDX (only recommended for upgrades of CRCS)
NOTE :
Lucent Technologies recommends the US Robotics Sportster 33.6 Faxmo-
dem for all new CRCS installations regardless of platform. However, if you
have one of the other faxmodems installed from a previous release of
CRCS, you may use it with CRCS 6.0. Follow the instructions in the previ-
ous
CRCS Installation manual for instructions on installing the Puredata
SatisFAXtion faxmodem. For all the other modems, follow the manufac-
turer’s instructions to install.